I ended up upgrading the horn connectors to EZ Clips and so the rod size increased as well. They are still a perfect fit in the tube, and the correct fit on the Du-Bro 2-56 Kwik Link.
I marked the push rods as shown in the manual and then cut and bent them to the 8mm requirement. I had to increase the horn hole size so that the rod would fit. Everything worked out fine.
Before I started, I used masking tape to ensure the elevator and rudder were straight. After fitting the receiver I found the servo position changed, and so I had to make a few adjustments.
Posted with Blogsy
No comments:
Post a Comment